Product page
Datasheet
Manual

Controlling a projection screen has never been this easy!
Get complete control when you pair the All-In-One Control Box with a motorized projection screen. This new accessory can be combined with motorized projection screens without a built-in RF receiver and offers the following options:
• Relay (dry-contact)
• RF (radiofrequency) control
• IR (infrared) control
• Manual Switch on the box
• 12 volt trigger

Relay (dry-contact)
Use the relay dry contact points in the control box to connect the screen to be operated with a third party control system. A control system includes the projection screen into the full room AV control.

RF (radiofrequency) control
Control the projection screen via a radio frequency remote control.
The remote control unit operates on frequency 433.92 MHz.
RF has an effective range up to 30 meters, depending on the local environment.

IR (infrared)
Control the projection screen via an infrared remote control. For infrared control a direct line of sight with the control box is needed. IR can be a solution for environments with restricted RF access.
Infrared has an effective range up to 8 meters.

Manual Switch
On the side of the control box you can find three buttons to control the projection screen directly. This additional control method function as a back-up to ensure the screen can still be operated even when connected control options fail.

12 volt DC trigger
Connect the 12 volt trigger option to any 12 volt output to trigger the projection screen. The 12 volt can be from a projector 12 volt trigger output or from an AV control system.

POWER SENSING TRIGGER (Option)
The Power Sensing trigger will be connected in between the power source and the projector. When the projector is turned on, the trigger senses power going to the projector and signal the projection screen to unroll. When the power is switched of the trigger will signal the projection screen to retract again. The Projecta Power Sensing Trigger only works in combination with the All-in-One Control Box

All-in-One Control Box are avalible for:
Tensioned Descender Electrol
Descender Electrol
Tensioned Elpro Concept
Elpro Concept
Compact Electrol
Extensa
Tensioned Descender Large Electrol
Descender Large Electrol
Tensioned Elpro Large Electrol
Elpro Large Electrol
Master Electrol

SPECIFICATIONS:
Power supply: AC 200-240V, 50 Hz +/- 10%
Operating temperature: 0 to 70 °C
RF Frequency: 433.92 MHz
IR Frequency: 38 KHz
Power consumption: ❤️00W / 0.4W in standby
Transmission power: < 10mW
Sensitivity: -110 dBm
Load capacity: ≤ 1000W



Forpakningsinfo

Forpaknings størrelse
244 x 189 x 114 mm
Forpaknings vægt
790 g